Looking for:
User manual GE Profile Opal XPIO13SCSS (English - 56 pages). |
- Ge profile opal countertop nugget ice maker manual
Create a solution of five cups of water and one. Plug in Opal and then hold the 'Clean' button. Making Ice. Water will begin circulating and the 'Cleaning'. See Figure 3. After a few minutes the. When the 'Cleaning' indicator light turns off,. Unhook the top of the drain. See Figure 4. Previous Page. Pull up to unhook 9. Clean the sensors with vinegar and wipe clean with water. After draining the vinegar, run three rinse cycles, using fresh water for each rinse.
Fill reservoir with potable safe to drink water up to water is misuse and will void your warranty. The rinse water should drain out the port in the back.
Cap and remove any residual soap see illustration. Drain tube B should always be connected to the Side Tank whether it is installed on the left or right side of the Opal Nugget Ice Maker. Page 14 Normal Operating Sounds and what may be creating them. Radio Frequency Interference This product has been tested and found to comply radio. If using vinegar, leave the vinegar in the unit for 18 hours and set a vinegar-soaked towel on the ice chute overnight to further dissolve any mineral buildup.
See figure Clean the sensors with vinegar and wipe clean with water. After draining the vinegar, run three rinse cycles, using fresh water for each rinse. See figures 11, 12, and 13 to reference location of the sensors. Appearance may vary based on model. Side Tank Troubleshooting If water does not flow from the Side Tank to the Opal Ice Maker: There may be bubbles in the tube connecting the side tank to the opal or it is not lying flat.
Try adjusting the tube to allow the water to flow. Once water starts flowing it typically will not need further adjusting. Download User Manual. ET Saturday - Sunday: 8 a.
Fan Page. Clean the sensors with vinegar and wipe clean with water. After draining the vinegar, run three rinse cycles, using fresh water for each rinse. Plug the ice maker into a grounded outlet.
Write the model and serial numbers here:.
No comments:
Post a Comment